TC-32B Chapter10 Subprogram function
2004/01/16 10 - 3 eTCOMNCPR10-1.doc
10
Special uses of M99
If the M99 command is executed in the main program, the control returns to the start of the
main program.
eNCPR11.02.ai
If the programming is done as shown above, and if the optional block skip is OFF, the control
returns to the start of the main program and executes the program repeatedly up to N0100.
If the optional block skip is turned ON, the N0100 block is omitted and control goes to the next
block.
10.2 Simple Call
A subprogram can be called out from the main program or another subprogram and executed
accordingly.
Command format M98 P_L_ ;
P : Subprogram number to be called.
L : Number of execution to be repeated. (Max. 9999)
If L is omitted, it is regarded as once.
(Note) If another G or M code is commanded in the M98 block, an alarm is
generated.
The axis movement is not available even by commanding X, Y or Z
address.
/N0100 M99;
N0200 M30;
When optional
block skip is off;
When optional
block skip is o
To Next Page
Loading...
