Brother TC-32B - Feed Function Overview

Chapter11 Feed function TC-32B
2004/01/22 11 - 2 eTCOMNCPR11-1.doc
11
11 Feed Function
Feedrate is specified by the number following address F.
(1) Command range
Metric system : 1~999999 mm/min
1~999999゜/min
Inch system : 0.1~99999.9 inch/min
0.1~99999.9゜/min
(2) Clamp
If the axis movement at a higher feedrate than the values specified by the machine parameter, an
alarm is generated.