Chapter 3 Preparation Function TC-32B
2004/01/22 3 - 6 eTCOMNCPR3.doc
3
Group G cord Contents Modal
G90* Absolute command
G91 Incremental command
Modal
G92 Working coordinate system setting One-shot
G94 Feed rate per minute
G98* Return to the initial point level
G99 Return to the R point level
Modal
G73 Canned cycle (High-speed peck drilling cycle)
G74 Canned cycle (Reverse tapping cycle)
G76 Canned cycle (Fine boring cycle)
G77 Canned cycle (Tapping cycle, synchro mode)
G78
Canned cycle (Reverse tapping cycle, synchro
mode)
G80* Canned cycle cancel
G81 Canned cycle (Drill, spot drilling cycle)
G82 Canned cycle (Drill, spot drilling cycle)
G83 Canned cycle (Peck drilling cycle)
G84 Canned cycle (Tapping cycle)
G85 Canned cycle (Boring cycle)
G86 Canned cycle (Boring cycle)
G87 Canned cycle (Back boring cycle)
G89 Canned cycle (Boring cycle)
Modal