Brother TC-32B - Page 88

Chapter4 Preparation function (Tool offset function) TC-32B
2004/01/22 4 - 6 eTCOMNCPR4.doc
4
4.1.3.3 Outside cutting ( θ < 90°)
(a)Type 1 : Linear - Linear
Type 1 : Linear - Arc
(b)Type 2 : Linear - Linear
Type 2 : Linear - Arc
(Note 1) Type 1 and 2 can be selected in parameter 1 for start-up and cancel
motions.
(Note 2) If the angle is close to 1°(θ
≤1°) while type 2 is being selected,
actualmovement will be type 1.