Bruker Fourier 300 - Page 124

124
Z31980_00_03
Pulse Programming
<Phase>
<Unit>quadrant</Unit>
<VarType>0</VarType>
<Quantity>4</Quantity>
<Val>0</Val>
<Val>2</Val>
<Val>1</Val>
<Val>3</Val>
</Phase>
<DataPoints>
<Unit>points</Unit>
<VarType>0</VarType>
<JcampKwd>##$TD</JcampKwd>
</DataPoints>
</ACQ_MULTI>
<RESETABS> switches to LO and starts the digitizer system. The timing of the acquisi-
tion is defined by <ACQ_MULTI>.
The acquisition duration is aq and it uses the phase cycle 0,2,1,3. TD data points are
acquired. A dwell time or spectrum width is not necessary, they are derived from aq and
TD.
Loops:
<P_LOOP>
<Start> </Start>
<Counter>
<Unit>counts</Unit>
<VarType>4</VarType>
<JcampKwd>##$L[4]</JcampKwd>
</Counter>
</P_LOOP>
….basic cycle….
<P_LOOP>
<Stop> </Stop>