80
Z31980_00_03
Configuration
7.2.2 4.3.2 CAN-Bus Devices
i
Notice: The procedure is the same for all devices.
The procedure is the same for all devices, however
• since the shim control board and the GAB/2 Board are slaves of the fourier main
board, the firmware update of these devices is initiated form the main board web
server.
•since the peripheral control board is a slave of the VTU, the firmware update of
this devices is initiated form the VTU web server.
This takes a few seconds and is fin-
ished when the message appears:
File ... uploaded successfully!
3. Press “Flash” to write the
uploaded file into the Flash
memory of the CPU.
This takes about a minute and is fin-
ished when the message appears:
Successfully Programmed Flash.
4. Reset the CPU by pressing the
Hardware Reset button.
5. Confirm the new version
after the CPU has been reset.
To Next Page
Loading...
