81
Z31980_00_03
Configuration
The procedure is started using
Main -> support -> AVR Controller software update
i
Notice: GAB/2 Backplane and Peripheral Control the Board Number is always “Board 1”
Since the shim control comprises two boards, this procedure has to be carried out twice.
Once for Board1 and once for Board2.
1. Select Device and
Board Number and press
SET.
2. Select the EEPROM file
(file ending *.eep) to be
uploaded by clicking on
Upload EEPROM Data.
This procedure takes less than
a second and is finished when
the message appears: Flash
EEP File.
3. Press Flash Eep-File to
write the file to the
EEPROM.
To Next Page
Loading...
