13
Z31980_00_03
3 Safety
This section provides an overview of all the main safety aspects involved in ensuring
optimal personnel protection and safe and smooth operation.
Non-compliance with the action guidelines and safety instructions contained in this man-
ual may result in serious hazards.
Read the following safety instructions carefully before you start installation or working
with the device.
3.1 General
Before you start any repair inside of the device, be aware of high voltages 230/115V.
Even if these voltages are protected by security features to avoid any contact with your
body, it is still possible that you unintentionally touch these voltages with a tool, e.g.
screwdriver etc.
Therefore, always check if you really need the power supply to be switched on during
your work. Otherwise turn the device off and disconnect the power cable from the wall
socket to the device. Avoid that anyone can re-power the system without your notice.
3.2 Personnel Requirements
3.2.1 Qualifications
i
Note: Only trained Bruker personnel are allowed to mount, retrofit, repair, adjust and dis-
mantle the unit!
To Next Page
Loading...
