Visual-ICE™ Cryoablation System
2-7
2.9.2 Software Reset
The Software Reset button is used to boot the Visual-ICE Cryoablation System into a recovery mode
if the software becomes corrupted (reference Section 7.1).
2.9.3 Power Control Knob
The Power Control Knob powers ON the Visual-ICE Cryoablation System in preparation for a
procedure.
2.9.4 Needle Channels
The Needle Connection Panel contains ten numbered needle channels; each channel contains two
ports to support connection of up to two cryoablation needles. Each channel operates independently
of all other channels in either freezing or thawing mode. The electrical connection is used for needles
with a memory chip, i-Thaw™, FastThaw™ or Cautery capabilities. The locking bar on each channel
locks the needles into the ports to secure them during the procedure.
To Next Page
Loading...