Reset
24
Logamatic 4323 - Subject to technical modifications.
116
24.2 Resetting the fault log
Using the "Reset fault log" function you can reset the whole fault memory.
This
deletes all entries in the fault log.
Call up the service level. "Gen. parameters" is shown as the first main menu.
Turn the rotary selector until the main menu "Reset" appears.
Briefly press "Display" to call up a submenu (here: "Factory settings Control
unit"). All
settings may be lost if you press for too long.
The display shows the selected submenu.
Turn the rotary selector until "Fault log" appears.
The display shows the selected submenu.
Press and hold down "Display".
The blocks in the last line disappear one after the other. The fault log is reset
after the final block has disappeared. Reset will be terminated if you release the
key before all blocks have disappeared. After implementing a reset, the display
automatically reverts to the next level up.
When terminating a reset, press "Back" to return to the next level up.