Buderus Logamatic 4323 Service Instructions

Heating circuit data
11
Logamatic 4323 - Subject to technical modifications.
48
11.7 Selecting remote control
Under this parameter, you can determine whether a remote control unit will be
installed for the heating circuit concerned. Here you can select the following:
– No remote control
– Remote control with display (MEC2) "MEC heat. circ."
If "Remote control with display" is selected for several heating circuits,
these
are grouped as "MEC heat.circ.".
– Remote control without display (BFU or BFU/F)
Explanations relating to "MEC heating circuits"
With the MEC2 you can control several heating circuits simultaneously.
These
are grouped together under the term "MEC heat. circ.".
The following functions can be carried out for "MEC heat. circ.":
– Changing the operating mode
– Adjusting the set value
– Summer/Winter Time adjustment
– Holiday function
– Party function
– Pause function
The heating circuits grouped together under "MEC heat. circ." can, for specific
settings, also be selected as "Single heat. circ".
The timer program "PROG" function is only available for each individual heating
circuit.
USER INFORMATION
No remote control unit may be installed for "Constant" heating circuit systems
or when "External changeover" has been activated.
A remote control unit must be installed to enable the following functions,
which
monitor the room temperature:
– Night setback with hold room temperature
– Max. room influence
– Automatic adaptation
– Optimisation
– "Room controller" heating system

Buderus Logamatic 4323 Specifications

General

Brand	Buderus
Model	Logamatic 4323
Category	Control Unit
Language	English