BUSKRO BK730-2 - Table of Contents

To Next Page

To Previous Page

BK730-2 Tabber

Buskro Ltd. BK730-2 Tabber

Table Of

Contents

1.0 General Information.............................................................................1-0

1.1 Description ............................................................................................................ 1-1

1.2 Features ................................................................................................................. 1-2

1.2.1 High Speed Production.................................................................................... 1-2

1.2.2 Integration with Buskro and 3

Party Equipment ........................................... 1-2

1.2.3 Simplified Mechanical Adjustments................................................................ 1-2

1.2.4 Software Controlled Tabber/Labeler Head Functions..................................... 1-3

1.2.5 Construction, Safety Features, and Maintenance............................................. 1-3

1.2.6 Tabbing Quality Considerations...................................................................... 1-3

1.3 Tabber/Labeler Base Specifications ................................................................... 1-5

1.4 Tabber/Labeler Head Specifications .................................................................. 1-6

1.5 Tabber/Labeler Base and Head Dimensions...................................................... 1-7

2.0 BK730-2 Base.........................................................................................2-0

2.1 Instrument Panel Functions ................................................................................ 2-1

2.1.1 Feed Disable Control ....................................................................................... 2-1

2.1.2 START Pushbutton.......................................................................................... 2-2

2.1.3 STOP Pushbutton............................................................................................. 2-2

2.1.4 JOG/RUN Selector........................................................................................... 2-2

2.1.5 Speed Control Module Connector ................................................................... 2-3

2.1.6 POWER Rocker Switch (Main Power)............................................................ 2-3

2.1.7 HEAD Rocker Switch (Head Power) .............................................................. 2-4

2.1.8 Production Speed Regulation Dial................................................................... 2-4

2.1.9 Tabber Connection Receptacle Panel .............................................................. 2-5

2.2 Upstream and Downstream Installation Instructions....................................... 2-6

2.2.1 Physical Alignment of Upstream/Downstream equipment.............................. 2-6

2.2.2 Electrical Connection to Upstream/Downstream equipment........................... 2-7

2.2.3 The Base Control Board (p/n 9102380A)........................................................ 2-8

2.2.4 The Speed Control Board (p/n 9102421)....................................................... 2-11

2.3 Product Setup Instructions................................................................................ 2-17

2.3.1 To adjust the base speed for smooth product transfer ................................... 2-17

2.3.2 Skidbar and Material Side Guide Adjustments.............................................. 2-18

2.3.3 Product Thickness Adjustment (Upper Transport)........................................ 2-22

2.4 Advanced Setup Instructions............................................................................. 2-23

2.4.1 Crease and Pinch Roller Adjustment............................................................. 2-23

2.5 Maintenance Schedule........................................................................................ 2-26

3.0 Tabber/Labeler Head (BK731-2).........................................................3-0

3.1 Mechanical Adjustments...................................................................................... 3-1

3.1.1 Tabber/Labeler Head Lateral Positioning........................................................ 3-1

3.1.2 Peel Point Setup for Different Product Thickness........................................... 3-2