BUSKRO BK730-2 - Label Spool Threading and Lateral Positioning

Chapter 3 Mechanical Adjustments Page 3-4
Figure 3-3: Peel Point Assembly
3.1.4 Label Spool Threading and Lateral Positioning
When initially loading on a new roll of labels, it is very important that the centerline of the
labels are aligned to the sensor location on the peel point as shown in
Figure 3-3. A
groove line on the peel point indicates the label sensor location. This line must be placed
at the center of the label. Labels that are sensed off-center will result in incorrect label
placement on the product.
In order to properly thread the labels, the following instructions as well as Figure 3-4
should be referenced:
1. Load the roll of labels onto the despool roll. Despooling is done in a clockwise
direction. Assemble the hub guide to the core to lock the roll of labels in place.
Buskro Ltd. BK730-2 Tabber