Chapter 3 Mechanical Adjustments Page 3-5
2. Pull back Pressure Roller 1 situated at the Despool Drive. The pressure roller
should lock in an open position. Repeat for Pressure Roller 2.
3. Rotate the Brush Pivot Arm off Idler 2.
4. Create a leader in the label backing paper by removing the labels from the first 18
to 24 inches of the label roll on the despool roll. This is to avoid having to clean
labels that are dispensed at the peel point during initial setup. Thread the leader
into the head as shown in Figure 3-4.
5. Position each individual label guide on the idler rollers so that they can guide the
label backing paper (see Figure 3-3). Ensure that they are not set too tightly.
6. Thread the label backing paper around the lock pin at the Take-Up roller. Rotate
the Take-Up roller a few revolutions in a clockwise manner to lock the backing
paper into place.
7. Ensure that the label backing paper is taut from the Despool Drive as shown in
Figure 3-4 and then pull the release knob on Pressure Roller 1.
8. Ensure that the label backing paper is resting straight on the Label Drive Roller
and then pull the release knob on Pressure Roller 2.
9. Rotate the Brush Pivot Arm clockwise in order to apply pressure against the label
backing paper.
Buskro Ltd. BK730-2 Tabber
To Next Page
Loading...