Safety Notices
Cadex Electronics Inc. C7000-C Series Battery Analyzers .
Shock Hazard
The Cadex Battery Analyzer contains high-voltage circuits, and can
pose a shock hazard when the upper cover is removed. Do not attempt
to perform any service procedures on the analyzer other than
replacement of the external fuse (see Chapter 11, Services and
Upgrades, page 100).
ü
To reduce the risk of electrical shock hazard, service batteries only when they are
removed and disconnected from their end-use equipment.
ü
Use the analyzer only as specified in the documentation. Other uses may impair the
protection provided by the unit.
ü Use only a grounded AC outlet to power the analyzer.
ü
Before attempting any internal service, remove all batteries from the battery stations,
turn the analyzer off and disconnect the power cord from the wall socket. Wait a few
minutes before opening the cover.
ü Replace fuses only with fuses of the same type and rating (see Replacing the Primary
(Input) Fuse, page 100).
To Next Page
Loading...
Need help?
General