Operation 225
Figure 247:
The 60 GHZ cnWave - Network Onboard
After the successful onboarding of the E2E Network, it can be managed through cnMaestro.
Figure 248:
The Onboard 60 GHZ cnWave E2E dashboard page
Auto Manage IPv6 Routes (External E2E Controller)
E2E Controller communicates with all nodes over IPv6. PoP nodes use IPv6 address of the statically
configured interface to communicate with E2E Controller. CNs and DNs use the IPv6 address derived
from Seed Prefix.
Note
The Auto Manage Routes feature requires cnMaestro 3.0.4.
The Auto Manage Routes feature adds and manages the IPv6 routes at E2E Controller. These IPv6 routes
are required for routing the IPv6 packets to CNs and DNs.
The feature is applicable only when PoP and E2E Controller are in the same subnet.
To Next Page