Canon imageCLASS MF264dw - Page 262

■ SYSTEM
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > SYSTEM
DOWNLOAD Shift to Download Mode
Detail To switch to the download mode.
Use Case
When upgrading the version
Adj/Set/Operate Method
1) Select the item, and then press OK key
2) Execute download using UST
Additional Functions
Mode
Menu > System Management Settings > Update Firmware
■ PARAM
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > PARAM
EXC-NAVI Set activation of Fax Setup Guide
Detail To set whether to activate the Fax Setup Guide. When executing this service mode, the message
"REBOOTING…"appears at the Control Panel, then the machine automatically reboots.
Caution
Set to "1"after completing the Fax Setup Guide.
If this is set to "1", the Fax Setup Guide will not be activated from the next boot.
Display/Adj/Set Range
0/1
0: Activate
1: Do not activate
Default Value
0
Supplement/Memo
Fax model only
■ SPLMAN
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > SPLMAN
TOP-MPT Adj lead edg mar: pickup from MP Tray
Detail As the value is changed by 1, the margin on the leading edge of paper is changed by 0.1 mm.
+: Leading edge margin becomes larger. (An image moves to the trailing edge.)
-: Leading edge margin becomes smaller. (An image moves to the leading edge.)
Use Case
When adjusting the leading edge margin of the paper being picked up from the Multi-purpose Tray.
Adj/Set/Operate Method
Enter the setting value, and then press OK or Apply key.
Display/Adj/Set Range
50 to 150
Unit
0.1 mm
Default Value
100
TOP-DUP-MPT Adj lead edg mar 2nd of 2-sided: MP Tr
Detail As the value is changed by 1, the margin on the leading edge of paper is changed by 0.1 mm.
+: Leading edge margin becomes larger. (An image moves to the trailing edge.)
-: Leading edge margin becomes smaller. (An image moves to the leading edge.)
Use Case
When adjusting the leading edge margin of the 2nd side of the 2-sided printing at the time of pickup
from the Multi-purpose Tray.
Adj/Set/Operate Method
Enter the setting value, and then press OK or Apply key.
Display/Adj/Set Range
50 to 150
Unit
0.1 mm
Default Value
100
8. Service Mode
254