Canon imagePRESS C10000VPSeries - Page 151

c-10) The end [a] of the shaft inserted in the step c-8) is where the ball bearing were in contact with. Apply the same amount of
the super lube grease as 2 grains of rice (approx. 40mg) to the entire circumference of this portion [a], and then attach the new
ball bearing (XG9-0779-000) and the E-ring.
c-12) Attach the parts by reversing the procedure from the step c-3).
[Service Parts]
No. Part Number Description Q'ty Fig.No.
1
Old FC6-2447-000 SHAFT, TRANSMISSION 1 -> 0
352
New FC6-2447-010 SHAFT, TRANSMISSION 0 -> 1
2
Old FC6-8472-000 SHAFT, TRANSMISSION 1 1 -> 0
352
New FC6-8472-010 SHAFT, TRANSMISSION 1 0 -> 1
3
Old FC5-9920-000 SHAFT, TRANSMISSION 1 -> 0
351
New FC5-9920-010 SHAFT, TRANSMISSION 0 -> 1
4
Old FY9-6005-000 SUPER LUBE GREASE 1 -> 1
New
5
Old XG9-0520-000 BEARING, BALL, MF106ZZS 5 -> 5
352
New
6
Old XG9-0779-000 BEARING, BALL, 688ZZNR D41 1 -> 1
351
New
[Countermeasure cut-in serial numbers in factory]
Model Serial No.
iPR C10000VP SR FS US WBE15173
iPR C10000VP SR FS EUO WBF15189
iPR C10000VP SR FS CN WBG15010
*As the production of imagePRESS C6000/C7000 Series, imagePRESS C6010/C7010 Series, imagePRESS C6011/C7011
Series has ended, there is no countermeasure cut-in serial numbers.
146