Canon imagePRESS C10000VPSeries - Information of Proactive Measure against E842-0 X21

Information of proactive measure against E842-0x21
[Detail]
If the W sems screw that secures the engagement/disengagement cam to the shaft is loosened, in the main engines before the
countermeasure in factory(S/N listed below), a large force might be applied to 20T/42T gear (FL3-7951-000) and 40T gear
(FU7-0828-010), which may lead to gear teeth damage.
Here is the information of the measure to prevent this symptom from occurring.
- E842-0121 : An error in engagement/disengagement operation of the Primary Fixing External Heat Belt was detected.
- E842-0221 : An error in engagement/disengagement operation of the Secondary Fixing External Heat Roller was detected.
[Service work]
If the W sems screw [1] that secures the engagement/disengagement cam to the shaft is found loosened by the inspection, tighten
up the W sems screw [1]. Or replace it with the w/washer screw (XA9-0961-000) [2] which has a locking member.
[Service parts]
No. Part Number Description Q'ty Fig.No.
1 Old 815
855
New XA9-0961-000 SCREW, W/WASHER, M4X10 0->4
[Countermeasure cut-in serial numbers in factory]
Model Serial number
imagePRESS C10000VP series FS US/J WBE10498
imagePRESS C10000VP series FS EUO WBF10547
imagePRESS C10000VP series FS CN WBG00522
223