SYSTEM AND USER SOFTWARE 108
7. At the message “System Software is copied to the system. Remove media and press OK to
reboot,” remove System Software DVD 1, and then select OK.
The imagePRESS Server reboots and the Control Panel displays messages as the installation
process continues. This segment takes approximately 20 minutes.
8. At the message “Please insert User Software to continue installation,” insert System Software
DVD 2 into the DVD/CD-RW drive.
During this process, the following installations are performed:
• The entire contents of System Software DVD 2 are copied to a shared folder on one of the
imagePRESS Server HDDs, in e:\efi\user_sw.
After installation, when the imagePRESS Server is connected to the customer’s network,
users can access the user software in the shared folder and install it onto client computers.
User Software is copied automatically once System Software DVD 2 is inserted into the drive.
The message “Copying user software to Fiery shared folder. Please wait.” displays on the
Control Panel, followed by other messages describing the user software installation process.
This segment takes approximately 20 minutes.
9. At the message “User Software installation complete. Remove CD/DVD. System will reboot,”
remove System Software DVD 2.
The system ejects System Software DVD 2 and reboots automatically. This segment
takes approximately four minutes. Wait for the system to boot completely, the
imagePRESS Server logo screen to appear on the imagePRESS Server Control Panel, and Idle
to appear on the Info screen on the copier touch panel (for details on accessing the Info
screen, see page 35).
NOTE: The imagePRESS Server takes approximately four minutes to finish rebooting and
display Idle on the Info screen of the copier touch panel. While the imagePRESS Server is
rebooting, the following message displays on the imagePRESS Server Info screen on the
copier touch panel: “Wait a while. (Check the power source of the print server behind the
main unit and cable connection if the display does not change in a moment.)” If the message
remains for longer than two minutes, verify that the copier interface cable is connected
correctly to the copier.
10. If user documentation was previously resident on the imagePRESS Server, advise the site
administrator to reinstall the documentation files from the User Documentation CD.
11. Advise the customer to check the System Updates feature for any required software patches
or updates that may be available for the imagePRESS Server (see “System updates” on
page 109).
12. Reconnect any USB devices or dongles that you may have removed earlier.
13. Configure Setup using the Configuration page that you printed earlier.
Access the Functions menu on the copier touch panel (see page 36) and scroll down and select
Run Setup. Bypass any settings that are not included on the Configuration page if it is more
appropriate for the network administrator to set them. For more information, see
Configuration and Setup on the User Documentation CD.
To Next Page