USING THE IMAGEPRESS SERVER 40
Print pages menu
This section describes how to print the Test Page and Configuration page from the Print
Pages menu (described on page 37). To navigate to the Print Pages menu from the copier
touch panel, scroll as follows: Copy screen > Printer screen > Info screen > Functions menu >
Print Pages menu.
Printing the Configuration page can be helpful during installation, Setup, and service. After
installing the imagePRESS Server (including connecting to the network), and before default
settings are changed in Run Setup, you can obtain a record of the defaults by printing the
Configuration page.
Before you perform any service procedure, you should print the imagePRESS Server
Configuration page, if possible, so that you are prepared to return the settings to their former
configuration, if necessary.
Printing the Test Page indicates that the imagePRESS Server is functional and that the
connection between the imagePRESS Server and the copier is working.
TO PRINT A PAGE FROM THE PRINT PAGES MENU
1. If it is not powered on, power on the copier and allow it to warm up.
2. If it is not powered on, power on the imagePRESS Server using the power button on the front
panel (see page 28) and allow it to start up completely (approximately three minutes).
3. Access the Info screen from the copier touch panel and make sure that Idle appears
(see page 35).
If Printing or RIPping appears, the imagePRESS Server is processing. You must wait until the
system finishes and reaches the Idle state.
4. Touch the Functions button.
5. Touch Print Pages, and then select the page that you want to print.
The imagePRESS Server sends the selected page(s) to the copier.
6. If you printed the Test Page, examine the quality of the page.
If the Test Page prints, you know the imagePRESS Server is functional and the connection
between the imagePRESS Server and the copier is working. If the Test Page fails to print, look
up printing problems in the Troubleshooting table on page 130.
When you examine the Test Page, keep in mind the following:
• All color patches should be visible, even though they may be very faint in the 5% and 2%
range.
• Each color’s patch set should show uniform gradation from patch to patch as the color
lightens from 100% to 0%.
Poor image or color quality may indicate a need to calibrate the system or service the copier.
Information on the Test Page includes the date and time of the last calibration, so the Test
Page can be kept for future reference. For more information, look up printing problems on
page 130, or see Color Printing on the User Documentation CD.
To Next Page
Loading...
