INSTALLATION 22
INSTALLATION
This chapter includes information about the following:
• Installation sequence (see below)
• Checking the customer site (see page 24)
• Unpacking the imagePRESS Server (see page 26)
• Installing the imagePRESS Server and connecting it to the copier and network (see
page 28)
• Completing the installation (see page 31)
– Print a Test Page and Configuration Page (page 40).
– Remind the site administrator to install current user software on networked computers
that print to the imagePRESS Server (see Printing and Utilities on the User
Documentation CD).
Installation sequence
Familiarize yourself with this chapter before you attempt an installation. The installation
sequence described in this chapter is designed to make your job as easy as possible. Installation
problems are easier to avoid and diagnose if you proceed from the component to the system
level and verify functionality at each stage. Figure 3 on page 23 outlines the recommended
installation procedure for connecting the imagePRESS Server to the copier.
Because the imagePRESS Server is a node on the customer’s computer network, make sure
that you coordinate your scheduled installation with the network administrator at the
customer site. For Network Setup information, refer the network administrator to
Configuration and Setup on the User Documentation CD.
NOTE: You can change the default language preinstalled at the factory using the Configure
tool available through Command WorkStation and WebTools. Start Configure, navigate to
Server > General > Choose Server Language, and then click Apply.
NOTE: Connecting to a different copier model — The imagePRESS Server is configured at the
factory to connect to a specific copier model within the supported copier series (listed in the
note on page 9). If the imagePRESS Server is later connected to a different copier model in
the series, it will auto-reboot approximately five minutes after it is powered on, in order to
establish communication with the different copier. The auto-reboot is normal and only
occurs the first time the imagePRESS Server is powered on with the different copier. Do not
press any buttons or interrupt the imagePRESS Server while it is rebooting.
To Next Page
Loading...
