SERVICE PROCEDURES 49
Accessing internal components
This section describes how to shut down and open the imagePRESS Server. Always use the
following procedures when opening the imagePRESS Server for inspection or service.
Shutting down the system
You can shut down the imagePRESS Server from the imagePRESS Server Control Panel or
the copier touch panel. When shutting down the imagePRESS Server, do the following:
• Remove the power cable from the back panel before removing or connecting interface
cables or accessing the internal components.
• Remember that when the imagePRESS Server is powered off, network access to the copier
is interrupted. Always obtain permission from the network administrator before you take
the imagePRESS Server off the network.
• If you are cycling power, wait at least 10 seconds before powering back on.
• If you are unable to shut down the imagePRESS Server through the Control Panel or the
copier touch panel, power off by holding down the power button on the front of the
imagePRESS Server for up to eight seconds.
• Using the reset button may cause the system to operate unpredictably. Use the reset button
on the front of the imagePRESS Server only if the system is frozen and unresponsive to
keyboard or mouse actions.
To Next Page
Loading...
