SYSTEM AND USER SOFTWARE 109
14. Reinstall technician-related software:
• Canon Software for Service Technical CD
• Operator Maintenance Assistance Software CD
The technician-related software is deleted when you install system software and must be
reinstalled.
For instructions, see the documentation provided on each CD.
15. Reinstall the Operator Maintenance Assistance Software CD.
The Operator Maintenance Assistance Software is deleted when you install system software
and must be reinstalled. For installation instructions, see the documentation provided on the
CD.
• If you installed an upgraded version of system software (for example, version 1.0 to version
2.0), contact your authorized service/support center for a list of valid software patches.
Some or all of the patches listed on the Configuration page that you printed earlier may no
longer be valid. Before installing a patch, be sure to verify with your authorized service/
support center that it is valid for your system version. Installing an invalid patch may result
in system corruption.
Software patches may be accessed from one or more of the following locations:
• System Updates—On the imagePRESS Server monitor (if present), choose Start >
All Programs > Fiery > System Updates, and then click Check Now. (For more
information, see “System updates” below.)
• The Functions menu area of the copier touch panel (see page 34).
• “Check for Product Updates”—In a Web browser, connect to the IP address of the
imagePRESS Server, click the Configure tab, and click “Check for Product Updates.”
16. Reinstall fonts or custom simulations that may have been deleted when you installed
software.
System updates
Advise the network administrator at the customer site that the System Updates feature
available through the Start menu on FACI-enabled systems allows customers to schedule and
accept installation of certain imagePRESS Server software updates from a secure site on the
Internet. By default, the feature is configured to display a notification on the monitor (if the
FACI option is present) that software updates are available for the imagePRESS Server. You
can also check for system updates via the monitor by choosing Start > All Programs > Fiery >
System Updates, and then clicking Check Now. Depending on how it is configured, System
Updates operates manually or automatically. For more information about how to schedule
System Updates, see Configuration and Setup on the User Documentation CD.
Microsoft Windows operating system updates should be obtained from Microsoft directly.
Because such updates are available directly from Microsoft, EFI does not maintain or provide
them via the System Updates feature.
To Next Page