Canon imagePRESS Server A2200 - Page 15

PREFACE 15
• Handle the imagePRESS Server LCD window with care.
If the imagePRESS Server LCD window breaks and the liquid crystal inside leaks out, avoid
contact with it. If you come in contact with the liquid crystal, wash it off your skin
immediately with soap and water.
• Use care when handling parts of the imagePRESS Server, as some edges on the unit may be
sharp.
• Do not install third-party applications onto the imagePRESS Server. Third-party applications
are not supported and can cause system problems. Although virus scans are permitted on the
imagePRESS Server, virus-protection software should not be loaded in memory-resident
mode.
• Do not change the Windows operating system software preference settings.
Depending on the changes made, the imagePRESS Server may become unstable or even
unusable. If this occurs, we recommend that you reinstall the imagePRESS Server System
Software, which reliably restores the Windows operating system software to its factory
defaults.
• Never alter an existing network without permission.
The imagePRESS Server will probably be connected to an existing Local Area Network
(LAN) based on Ethernet hardware. The network is the link between the customer’s
computer, existing laser printers, and other prepress equipment. Never disturb the LAN by
breaking or making a network connection, altering termination, installing or removing
networking hardware or software, or shutting down networked devices without the
knowledge and explicit permission of the system or network administrator or shop supervisor.
• Unless you are the network administrator, never assign an IP address in imagePRESS Server
Network Setup.
In a DHCP environment, the system assigns the IP address automatically. In a non-DHCP
environment, you should enter only the IP address that has been assigned by the network
administrator. Only the network administrator should assign an IP address to a network
device. Assigning the imagePRESS Server an incorrect IP address may cause unpredictable
errors on any or all devices connected to the network.