Canon imagePRESS Server A2200 - Page 43

USING THE IMAGEPRESS SERVER 43
TO SHUT DOWN, RESTART, OR REBOOT FROM THE IMAGEPRESS SERVER CONTROL PANEL
1. Make sure that the Info screen on the copier touch panel displays Idle (see page 35).
If Printing or RIPping appears on the touch panel, the imagePRESS Server is processing. You
must wait until the system finishes and reaches the Idle state.
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the shutdown procedure.
NOTE: Notify the network administrator before you remove the imagePRESS Server from
the network.
2. At the imagePRESS Server Control Panel, press the Menu button.
3. Select Restart Server, Shut Down System, or Reboot System.
Before accessing internal components, make sure that all cables are disconnected from the
back of the imagePRESS Server.
TO SHUT DOWN, RESTART, OR REBOOT THE IMAGEPRESS SERVER FROM THE COPIER TOUCH PANEL
1. Navigate to the Info screen on the copier touch panel (see page 35).
2. Make sure that the Info screen reads Idle.
If Printing or RIPping appears on the touch panel, the imagePRESS Server is processing. You
must wait until the system finishes and reaches the Idle state.
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the shutdown procedure.
NOTE: Notify the network administrator before you remove the imagePRESS Server from
the network.
3. Press the Functions button to display the Functions menu.
4. Press the Shut Down button.
5. Select Restart Server, Shut Down System, or Reboot System.
Before accessing internal components, make sure that all cables are disconnected from the
back of the imagePRESS Server.
Eject CD/DVD
Restart Server
Shut Down System
Reboot System
Functions
Use the line selection button to the right to select
Restart Server, Shut Down System, or Reboot System.
Use the line selection buttons to select Restart Server,
Shut Down System, or Reboot System.