Handling rolls
1. Lift the Holder Stopper lever (a) from the shaft side to unlock it. Holding the Holder Stopper at
the position indicated (b), remove it from the Roll Holder .
2. When using a 3-inch paper core, align the tips (a) of 3-Inch Paper Core Attachment #1 with the
holes (b) of the Roll Holder and insert it rmly .
3. With the edge of the roll paper facing forward as shown, insert the Roll Holder from the right of
the roll. Insert it rmly until the roll touches the ange (a) of the Roll Holder .
Important
• Insert it rmly so that there is no gap between the roll and the ange of the Roll Holder . If there is a
gap, it may cause feeding problems.
• When loading a roll, be careful to avoid hitting the printer hard with the roll. This may damage
the Roll Holder .
1 16 Handling Paper
To Next Page
Loading...
Need help?
General