Network Setting
Specifying Printer-Related Information
Follow the steps below to specify device information and security settings.
1. Start the web browser and enter the following URL in the Location (or Address ) box to display
the RemoteUI page.
http:// “printer IP address or name” /
Example: http://xxx.xxx.xxx.xxx/
2. Select Administrator Mode and click Logon .
3. If a password has been set on the printer , enter the password.
4. Click Information in the Device Manager menu at left to display the Information page.
5. T o display the relevant settings page, click Edit in the upper-right corner of Device Information
or Security , depending on what information you want to specify .
6. Refer to the table of settings for device information, security , and email notication as you
complete these settings.
Device Information Settings
Item Details
Default Setting
Device Name Enter a device name.
(0-32 characters)
blank
Location Enter the location where the device is installed.
(0-32 characters)
blank
Administrator Enter the administrator ’ s name.
(0-32 characters)
blank
Phone Enter the administrator ’ s contact information.
(0-32 characters)
blank
Comments(E-mail) Enter any comments regarding the administrator .
(0-32 characters)
blank
Security Settings
Item Details
Default Setting
Old Password Enter the current device password.
(0-14 characters)
blank
New Password Enter the new password.
(0-14 characters)
blank
Conrm Enter the new password again to conrm it.
(0-14 characters)
blank
Besides entering a password, you can specify other security-related information, such as IP
address-based SNMP or TCP usage restrictions, MAC address-based access restrictions, or
IPP and FTP authentication settings.
7. Click OK to activate the settings.
Network Setting 453
To Next Page
Loading...
Need help?
General