HP-GL/2 problems
HP-GL/2 problems
Lines or images are missing in the HP-GL/2 data that
was printed.
Cause Corrective Action
The memory is full. Check the size of the data in the print job.
An HP-GL/2 command not supported by this printer
was received.
Check the print job and settings.
The printer has received print data that includes HP
R TL commands when Auto Rotate is On .
Set Auto Rotate to Off before attempting to print
again.
( → P .53)
Lines Are Printed T oo Thick or Thin During HP-GL/2
Printing
Cause Corrective Action
The Line W idth setting in the main menu is incorrect. Conrm the selection in Line W idth . If ne lines are
printed faint, setting ThickenFineLines to On in the
main menu will print the lines more distinctly .
( → P .53)
HP-GL/2 jobs are printed in monochrome (or color).
Cause Corrective Action
The Color Mode is incorrect. On the printer Control Panel , check the Color Mode
setting.
( → P .53)
However , for optimal Printhead performance, the
printer consumes trace amounts of color ink even
when Monochrome is selected as Color Mode .
Printed Colors in Line Drawings are Inaccurate During
HP-GL/2 Printing
Cause Corrective Action
AdjustFaintLines in the main menu is set to On . Selecting Off may help produce the expected results.
However , lines in some colors may appear broken.
HP-GL/2 printing takes a long time.
Cause Corrective Action
Large print jobs with a lot of data take longer to print. On the printer Control Panel , set Input Resolution to
300dpi .
( → P .53)
640 T roubleshooting
To Next Page
Loading...
