Handling sheets for paper feed slots
Handling sheets for paper feed slots
Selecting the Paper Source
When advancing paper , press the Feeder Selection button and select the source.
Y ou can determine the selected source by checking which lamp is lit-either the Roll Media lamp (a) or the
Cut Sheet lamp (b).
• Roll Media lamp : Selected when printing on Roll Media .
• Cut Sheet lamp : Selected when printing on Sheets .
Note
• If a sheet is loaded when you change the paper source to a roll, Eject sheet? is displayed. Press
the OK button and remove the sheet.
• Y ou cannot switch the paper source in the following situations:
• When the Message lamp is ashing
Check the message on the Display Screen and take action as necessary . ( → P .647)
• When the Data lamp is ashing
Select the paper source after printing is nished.
• When a printer menu operation is in progress
W ait until the operation is nished before selecting the paper source.
• When in the process of loading paper
Finish loading the paper before selecting the paper source.
• When in the process of replacing Ink T ank
Finish replacing the Ink T ank before selecting the paper source.
• When the T op Cover is open
Close the T op Cover before selecting the paper source.
148 Handling Paper
To Next Page
Loading...
Need help?
General