Handling rolls
5. Use a size of paper that matches the width specied in the print job.
When both loaded rolls match the width of paper in the print job or the width is not specied in
the job, the sixth condition determines which roll is used.
When W idth Detection is set to Off , the seventh condition determines which roll is used.
Note
• When neither loaded roll matches the width specied in the print job, an error message is displayed.
6. Use a size of paper that accommodates the width specied in the print job.
When both loaded rolls can accommodate the width specied in the print job, the seventh
condition determines which roll is used.
Note
• When Detect Mismatch in the printer menu is set to W arning or None , the roll is determined
by the following conditions.
• When neither loaded roll is wide enough for the print job and Detect Mismatch in the printer menu is
set to Pause , an error message is displayed.
7. The roll closest to the roll width specied in the print job is used.
If both rolls are equally close to the specied width, the currently advanced roll is used.
Handling Paper 147
To Next Page
Loading...
Need help?
General