Messages regarding paper
Insufcient paper for job
Cause Corrective Action
Press the Online button to resume printing.
However , the roll paper may run out during the
print job and you may not be able to print all of the
document.
The printer has received a print job longer than the
amount of roll paper left when ManageRemainRoll
in the printer menu is On and one of the following
settings is selected.
• An option other than Roll Paper (Auto) is selected
in Paper Source in the printer driver .
• During HP-GL/2 printing, GL2 Settings > Paper
Source in the printer menu is set to an option
other than Automatic .
Hold down the Stop button for a second or more to
cancel printing.
Either change the printer driver Paper Source setting
or the GL2 Settings > Paper Source setting in the
printer menu or replace the roll with a roll that has
enough paper for the print job, and then try printing
again.
( → P .125)
( → P .1 18)
This paper cannot be used.
Cause Corrective Action
Paper that is too large for the printer has been loaded. Lift the Release Lever and load paper of the correct
size.
( → P .109)
Paper that is too small for the printer has been
loaded.
Lift the Release Lever and load paper of the correct
size.
( → P .109)
Paper has been loaded that is too small to print
the test pattern for printhead adjustment or nozzle
checking.
Lift the Release Lever and load unused paper A4
or larger . More than one sheet may be required
depending on the adjustment.
Cannot print as selected. Another roll is in use.
Cause Corrective Action
A printed document remains in the Output T ray
without being cut and a print job was received that
species the other roll.
Follow these steps to load the other roll after cutting
the printed document.
1. Hold down the Stop button for a second or more
to cancel printing.
2. Cut the printed document.
( → P .139)
3. Load the other roll and resend the print job.
( → P .89)
Error Message 653
To Next Page
Loading...
Need help?
General