To Next Page

To Previous Page

Messages regarding paper

Roll x is empty . (x is 1 (Upper) or 2 (Lower))

Lift the release lever and replace the roll.

Cause Corrective Action

The roll is empty . Follow these steps to replace the used roll with a new

roll of the same type and size.

1. Lift the Release Lever and remove the roll.

( → P .125)

( → P .129)

2. Load the new roll.

( → P .1 15)

( → P .1 18)

3. If no barcode was printed on the roll, specify the

type of paper .

( → P .1 13)

4. If no barcode was printed on the roll, specify the

paper length.

( → P .1 14)

5. If Not nished printing. Finish printing

remaining jobs? is shown on the Display Screen ,

press the OK button.

Printing will resume, starting from the page on

which the error occurred.

There is remaining roll paper , but because it could

not be advanced, it could not be detected.

Choose a higher level of Print Quality in the

Advanced Settings of the printer driver and try

printing again.

( → P .21 1)

Press OK.