Handling sheets for paper feed slots
Manually Loading Paper to the Position for Printing
When printing on non-standard sizes of paper or to specify a particular position to start printing, in the printer
menu set W idth Detection to Off for the paper used.
Setting W idth Detection to Off will prevent paper from being automatically advanced to the position for printing. In
this case, manually load paper at the position for printing.
Instructions for manually loading paper at the position for printing when W idth Detection is set to Off are
as follows.
1. If you send a print job from a computer beforehand, the type and size of paper are shown on the
Display Screen . Lift the Release Lever and open the T op Cover .
Important
• Do not touch the Linear Scale (a), Carriage Shaft (b), or Ink T ube Stabilizer (c). T ouching these
parts may damage them.
Handling Paper 153
To Next Page
Loading...
Need help?
General