Handling sheets for paper feed slots
2. Keeping the right edge of the paper aligned with the extended line of the Paper Alignment
Line (a) on the right side of the printer , load the paper so that the near edge is aligned with
the groove (b) at the far end of the Platen .
In this case, advance the paper as far into the paper feed slot as possible because it will
be printed starting at that position.
3. Lower the Release Lever and close the T op Cover .
4. If no print job has been received from the computer , press ▲ or ▼ to select of the type of
paper loaded, and then press the OK button.
5. When W idth Detection OFF . OK to continue? is shown on the Display Screen , press ▲ or ▼
to select Leave OFF and then press the OK button.
6. Check the position of the loaded paper and press the OK button.
7. Press ▲ or ▼ to select the paper size, and then press the OK button.
Note
• If a print job received requires paper larger than the selected paper , it may soil the Platen .
154 Handling Paper
To Next Page
Loading...
Need help?
General