Problems with the printing quality
The surface of the paper is dirty
Cause Corrective Action
The Paper Retainer is soiled. Clean the Paper Retainer .
( → P .597)
Y ou are using a paper that does not dry easily . Specify a time of about a minute in Roll DryingT ime .
The back side of the paper is dirty
Cause Corrective Action
Open the T op Cover and clean the Platen .
( → P .597)
The Platen has become dirty after borderless printing
or printing on small paper .
Set CarriageScanWdth to Fixed .
Activate width detection, and open the T op Cover and
clean the Platen .
( → P .597)
The Platen has become soiled due to printing on the
Platen because width detection is deactivated.
Open the T op Cover and clean the Platen . After this,
manually advance the roll onto the Platen before
printing.
( → P .597)
( → P .135)
The Paper Retainer is soiled. Clean the Paper Retainer .
( → P .597)
624 T roubleshooting
To Next Page
Loading...
Need help?
General