Messages regarding paper
Paper size not detected.
Cause Corrective Action
Follow these steps to reload the roll.
1. Lift the Release Lever .
2. Open the T op Cover .
3. Adjust the right edge of the roll to make it parallel
to the right Paper Alignment Line .
4. Lower the Release Lever .
5. Close the T op Cover .
6. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
( → P .1 18)
If this error recurs after you reload the roll, remove
the Roll Holder from the printer , push the roll rmly in
until it touches the Roll Holder ange, and reload the
Roll Holder in the printer .
( → P .1 15)
Paper has been loaded askew , or warped paper has
been loaded.
Follow these step to reload a sheet.
1. Lift the Release Lever .
2. Open the T op Cover .
3. Adjust the right edge of the sheet to make it
parallel to the right Paper Alignment Line and the
trailing edge of the sheet to make it parallel to the
paper alignment line under the Paper Retainer .
4. Lower the Release Lever .
5. Close the T op Cover .
6. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
( → P .150)
652 Error Message
To Next Page
Loading...
Need help?
General