Printing enlargements or reductions
7. In the L Paper Source list, click to select the feed method set for the specied paper . In this
case, choose from Roll Paper (Auto) , Roll Paper 1 , or Roll Paper 2 .
8. Select the width of the loaded roll in the M Roll Paper W idth list-in this case, ISO A2/A3 Roll
(420.0mm) .
9. In the A Page Size list, click the size of the original as specied in the application. In this
case, click ISO A4 .
10. Select the C Enlarged/Reduced Printing check box.
1 1. Click ISO A4 in the G Paper Size list.
12. Click F Scaling and enter “120” .
Note
• Y ou can specify enlargement that exceeds the paper size, but in this case, the portion of f the edge of
the paper will not be printed.
• If the original size after enlargement or reduction is smaller than the paper size, the original is
printed in the upper-left corner . In this case, you can center originals by selecting G Print Centered
on the Layout sheet.
13. Conrm the print settings and print as desired.
Note
• For tips on conrming print settings, see “Conrming Print Settings (Windows)”. (→P .374)
242 Enhanced Printing Options
To Next Page
Loading...
Need help?
General