Borderless Printing
Borderless Printing by Resizing Originals to Fit the Roll
W idth (W indows)
This topic describes how to enlarge originals before borderless printing to match the roll width, based on the
following example.
• Document: Any T ype
• Page size: A4 (210.0×297.0 mm [8.3×1 1.7 in])/Letter
• Paper: Roll
• Paper type: Heavyweight Coated Paper
• Roll paper width: 10 inches (254.0 mm)
1. In the application, create an original that takes up the entire space of the paper size.
Note
• If you can specify the margin, as in Microsoft W ord, set the margin at 0 mm. For instructions on
specifying the margin, refer to the software documentation.
2. Choose Print in the application menu.
3. Select the printer in the dialog box, and then display the printer driver dialog box. ( → P .381)
4. Make sure the Main sheet is displayed.
5. In the A Media T ype list, select the type of paper that is loaded. In this case, click Heavyweight
Coated Paper .
6. Make your selection in the E Print T arget list.
274 Enhanced Printing Options
To Next Page
Loading...
