Printing banners or at other non-standard sizes
Printing V ertical or Horizontal Banners (Large-Format
Printing; Mac OS X)
This topic describes how to print a banner about ve times as long as the roll width based on the following example.
• Document: An original designed for a horizontal banner
• Page size: Non-standard (100×500 mm [3.9×19.7 in.])
• Paper: Roll
• Paper type: Plain Paper
• Roll paper width: 16 inches (406.4 mm)
Follow the steps below to print a banner in either horizontal or vertical format.
1. In the application, create an original in the format of a horizontal or vertical banner .
2. Register a “Custom Page Size.”
Banners tend to be in non-standard sizes, so register a “Custom Page Size” in Page Setup . In this
example, 100×500 mm (3.9×19.7 in) is registered.
3. Print the banner , using the settings that correspond to banners.
Note
• The following procedures are based on Mac OS X 10.4. The method of setting up non-standard paper
sizes varies depending on the version of Mac OS X.
Enhanced Printing Options 293
To Next Page
Loading...
