Cleaning the Printer
Important
• Do not touch the Linear Scale (a), Carriage Shaft (b), or Ink T ube Stabilizer (c). T ouching these
parts may damage them.
A void cleaning where the Carriage is retracted, in position (d) or (e).
Note
• If the Cleaning Brush is dirty , rinse it in water .
3. Using a damp cloth that you have wrung out completely , wipe away dirt or paper dust (debris
from cutting) inside the T op Cover .
Wipe away any ink residue and paper dust (debris from cutting) on the T op Cover Roller (a),
all over the Platen (b), the Paper Retainer (c), the Borderless Printing Ink Grooves (d), the
Ejection Guide (e), the blue Switch (f), the section around the right-side Borderless Printing
Ink Grooves (g), and so on.
598 Maintenance
To Next Page
Loading...
Need help?
General