Chapter 8
8-9
Cannot print
as specified.
Press Load/Eject
and replace paper
with A4/LTR
(vertical) or larger
03010000-2E1F Undersized paper loaded for internal
printing (A4 or larger)
Replace with A4/Letter or any larger-sized paper.
Cannot print
as specified.
Press Load/Eject
and replace paper
with A3/11"x17"
(vertical) or larger
03010000-2E1F Undersized paper loaded for internal
printing (A3 or larger)
Replace with A3/11"x17" or any larger-sized paper.
Cannot print
as specified.
Press Load/Eject
and replace roll
with 10 in. wide or
larger roll.
03010000-2E1F Undersized paper loaded for internal
printing (roll media)
Replace with roll media at least 10 inches in width.
Cannot print
as specified.
Press Load/Eject
and replace paper
with A2/16.6"x23.4"
(vertical) or larger
03010000-2E1F The first sheet used for adjustment
printing or the like was A2 or larger-
sized but the second sheet used was
smaller than A2.
Prepare about 10 sheets of A2 or larger-sized paper.
Replace with A2 or any larger-sized paper.
Cannot feed paper.
Remove paper and
press Load/Eject.
03010000-2E25 Feeding error Remove the paper jam and reload the paper.
Cannot detect papr
Remove paper and
press Load/Eject.
03010000-2E25 Paper jam while feeding/ejecting/
printing
Remove the paper jam and reload the paper.
Cannot load.
Press Load/Eject
and reload the
paper.
03010000-2E27 Paper jam during feeding/printing/
ejection
Reload the paper.
This paper
cannot be used.
Check supported
paper sizes.
Load/Eject:
Change Paper
03010000-200E Undersized paper (cut sheets/roll
media)
Replace with larger-sized paper.
This paper
cannot be used.
Check supported
paper sizes.
Load/Eject:
Change Paper
03010000-200F Oversized paper (cut sheets/roll media) Replace with smaller-sized paper.
No sheets.
Press Load/Eject
and reload the
paper.
03010000-2016 Paper worked out of position while
printing
Reload the paper
Use another paper.
Press Online to
clear the error.
03010000-2F33 Unadjustable because of transparent
media
Replace with adjustable media.
Paper loaded
askew.
Press Load/Eject
and reload the
paper.
03016000-2010 Skew Correct the skew in the paper and reload it.
Hardware error.
03130000-2E21
Turn off printer,
wait, then
turn on again.
03130000-2E21 IEEE1394 interface error Check that the optionalIEEE1394 board is mounted.
Check the cable connection.
Wrong paper type.
Stop: Stop Printing
Load/Eject:
Change Paper
03061000-2E15 The first and second sheets used for
adjustment printing or the like differed
in paper type.
Prepare paper of the same type as used for the first
sheet for adjustment printing or the like.
Display massage Code* Condition detected Action
To Next Page
Loading...
