Chapter 1
1-66
[Interface Setup]
T-1-23
[Maintenance]
T-1-24
Setting Item Description/Instructions
[EOP Timer] Specify the timeout period for print jobs.
[TCP/IP] [IP Mode] Choose whether the printer IP address is configured automatically or a static IP address is
entered manually.
[Protocol] [DHCP] Specify the protocol used to configure the IP address automatically.
[BOOTP]
[RARP]
[IP Setting] [IP Address] Specify the printer network information when using a static IP address.
Enter the IP address assigned to the printer, as well as the network subnet mask and default
gateway.
[Subnet Mask]
[Default G/W]
[NetWare] [NetWare] Specify the NetWare protocol. To apply your changes, choose Store Setting .
[Frame Type] Specify the frame type to use.
[Print Service] Choose the print service.
[AppleTalk] Specify whether to use the AppleTalk protocol. To apply your changes, choose Store Setting .
[Ethernet Driver] [Auto Detect] Specify the communication method. To apply your changes, choose Store Setting .
Choose On for automatic configuration of the LAN communication protocol. Choose Off to use
settings values of Comm.Mode and Ethernet Type .
[Comm.Mode] Choose the LAN communication method.
[Ethernet Type] Choose the LAN transfer rate.
[Spanning Tree] Choose whether spanning-tree packets are supported over the LAN.
[MAC Address] Displays the MAC address.
[Init. Settings]
A confirmation message is displayed if you press the button. Choose [OK] to restore the
network settings to the default values.
Setting Item Description/Instructions
[Maint. cart.] When exchanging the maintenance cartridge, choose Yes and follow the instructions on the
screen.
[Replace P.head] Not displayed during a warning message that the remaining Maintenance Cartridge capacity is
low.
When replacing the Printhead , choose Yes and follow the instructions on the screen.
[Move Printer] Not displayed during a warning message that the remaining Maintenance Cartridge capacity is
low.
When transferring the printer to another location, choose Yes and follow the instructions on the
screen.
[Clean Platen] Use this function to clean inside the Top Cover . After you select Yes , the Carriage is moved
in preparation for Platen cleaning.
To Next Page
Loading...
