LUBRICATION/FILTERS/FLUIDS
172
LEFT PAGE
Bur 6-34090EUR
9. Open the left bleed screw on the
front axle.
BD00B027
1. BLEED SCREW ON FRONT AXLE
10. Slowly push down on the brake
pedal until oil begins to flow from
the bleed screw. Hold the brake
pedal in position until 1 liter of oil
has been bled and/or there is no air
bubbles in the oil flowing from the
bleed screw. Close the bleed screw
and release the brake pedal.
NOTE: DO NOT push the brake pedal
farther than necessary to cause the oil
to flow from the bleed screw. The
farther you push the pedal the higher
the pressure in the brake circuit. High
pressure can cause injury or damage.
11. Open the right bleed screw on the
front axle. Repeat Step 10
12. Start and run the engine at idle for
2 minute.
13. Stop the engine. Open the left
bleed screw on the rear axle.
Repeat Step 10.
14. Open the right bleed screw on the
rear axle. Repeat Step 10.
15. Check the brake system for correct
operation. If the brake system is
not operating properly see the
Service Manual or your Case
Dealer.
1
To Next Page
Loading...
