INSTRUMENTS/CONTROLS
54
LEFT PAGE
Bur 6-34090EUR
INFORMATION CENTER
BD02B020
To program your information center do the following:
1. Turn the key switch to the ON position.
2. Put the Information Center into the program mode by pressing the program
switch down (C).
3. Up count (A) to program location 010.
4. Center the program/reset (C, D) switch. This will allow you to adjust to the
desired value. You can personalize the cluster to your use (See Gauge
Displays in this manual).
5. When adjusted you can push the program/reset (C, D) switch momentarily to
the reset position. You have completed the change.
Service Interval Hours
Locations 61 through 70 are service interval hour settings. The service interval
hours will accumulate hours until they are reset. Once they are reset, they will
begin accumulating hours independent from the machine hours until they are
reset again.
A. UP COUNT C. PROGRAM
B. DOWN COUNT D. RESET
1
A
B
C
D
To Next Page
Loading...
