EasyManua.ls Logo

Case 921C - Page 91

Case 921C
244 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTRUMENTS/CONTROLS
85
RIGHT PAGE
Bur 6-34090EUR
SIDE CONSOLE
BD02B022
12. AUTOSHIFT SWITCH:
The autoshift switch is used to select the automatic or manual mode
of operation for the transmission. When the autoshift switch is in the
ON position the transmission will automatically shift UP and DOWN
between 1st or 2nd and the highest speed setting on the transmission
lever (see Transmission Operation in this manual for complete
operation).
13. RIDE CONTROL SWITCH:
Push down on the top of the Ride Control switch and pull back on the
Loader Lift Control Lever to raise the lift arms until the Green light in
the Ride Control Switch intensifies for the ON position. Push the
bottom of the switch for the OFF position. Ride Control is OFF when
key switch is OFF. Ride Control Must be reset once the engine is
started again. (see Ride Control Operation in this manual for operation).
14. REAR WIPER/WASHER SWITCH (IF EQUIPPED):
The rear wiper/washer switch has three positions.
A.OFF - The switch completely off when the bottom of the switch is
pushed down.
ON - Push down on the top of the switch for the ON position
WASH - Push down on the top of the switch and hold, washer fluid will continue to
flow as long as the switch is held down.
12
13
14
BC00B081
BC00B094
BC00B083
Copyright ©

Table of Contents

Related product manuals