© Cesab 3 – 2 T Code(s): 841, 842, 843
Repair manual: General safety rules Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040 Date: 2018-05-01 Applies from serial number: 6384351-
DANGER!
The hydraulic system can be damaged.
If the oil is contaminated, the hydraulic components will suffer damage.
Always use new and clean oil in the hydraulic system.
• Store and transport changed oil according to applicable local directions.
• Do not flush solvents, etc. down the drain unless they are intended to be
disposed of in this way.
Follow local disposal regulations.
• Disconnect the battery prior to performing any welding work on the truck.
Note:
The battery could be damaged.
When welding with an electric welding unit, the current may enter the battery.
The battery must be disconnected.
• Prior to welding or grinding on painted surfaces, be sure to remove the
paint at least 100 mm around the welding/grinding area by using
sandblasting equipment or paint remover.
DANGER!
Harmful gasses.
Heated paint gives off harmful gases.
Remove all paint within 100 mm of the welding/grinding site.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
