© Cesab 7 – 1 T Code(s): 841, 842, 843
Repair manual: Maintenance Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040 Date: 2018-05-01 Applies from serial number: 6384351-
7. Maintenance
7.1 Introduction
To maintain a high level of truck safety and to minimise downtime, all the
points specified in the service programme must be carried out.
The intervals specified are those that fulfil the truck manufacturer's
requirements for a truck used in standard applications. The local operating
environment may require service intervals that differ from those specified.
Once a truck's service intervals have been determined, the hour recorder is
primarily used for determining when servicing is to be carried out.
To maintain truck safety, only spare parts approved by the truck manufacturer
may be used for servicing and repairs.
During the truck's warranty period: If repairs/servicing have been carried
out by non-authorised personnel, or if non-approved spare parts are used,
the truck warranty ceases to be valid.
7.2 Maintenance instructions
7.2.1 Cleaning and washing
Cleaning and washing the truck is an important factor in maintaining truck
reliability.
• Carry out general cleaning and washing each week.
Note:
Risk of short circuiting.
Risk of damage to the electrical system.
Disconnect the battery before washing by pulling out the battery connector.
7.2.2 High-pressure washers
High-pressure washing may only be performed on metal surfaces.
Under no circumstances may high-pressure washing be performed in the
truck's motor compartment.
When using a high-pressure wash, the jet must be directed in such a way that
it does not damage electric cables, electric sensors, hydraulic hoses or
decals.
Lifting chains, piston rods and end pieces of hydraulic cylinders, ball and
roller bearings – including those that are fully enclosed – must not be
exposed to the jet, as there is a risk that water may penetrate and cause
corrosion.
After performing a high-pressure wash, all bearings and chains must be
lubricated/greased as specified in the maintenance instructions.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
Need help?
General
