3.1.13-84
CS35 2013.04
3.1.13-84Electronic Control System - ME7
P0365, P0366,
P0367, P0368
Exhaust phase sensor signal fault
Remove circuit faults
between intake air
phase sensor and
ECM, or replace the
intake air phase sen-
sor
P0420 Catalytic converter efficiency low
Replace the catalytic
converter
P0444, P0458,
P0459
Carbon canister solenoid circuit
fault
Disable the canister purge
feature
Remove circuit faults
between carbon canis-
ter solenoid and ECM,
or replace the solenoid
P0480, P0481
Low - speed fan and high - speed
fan faults
Remove circuit faults
between fan and ECM
P0501 Speed sensor signal fault
1. The stepper motor self -
learning function turns off.
2. Close the bm speed ref-
erence point diagnosis.
3. Idle diagnosis off
4. The battery voltage diag-
nosis is closed
Remove circuit faults
between vehicle speed
sensor and TCM, or
replace the vehicle
speed sensor
P0506 Idle speed too low
Disable idle speed regula-
tion
Remove idle control
circuit, ETC or ignition
system faults
P0507 Idle speed too high
Disable idle speed regula-
tion
Remove ignition sys-
tem fault, vacuum
leakage, circuit faults
between ETC and
TCM, or ETC fault
P0560, P0562
and P0563
System battery voltage is unrea-
sonable
Remove the charging
system faults or
replace ECM
P0564 Cruise control fault
Forbid the cruise control
function
Repair faults or
replace wiring harness
P0571 Brake switch signal circuit fault
Remove circuit faults
between brake switch
and ECM, or replace
the brake switch
P0602, P0604,
P0605, P0606
ECM fault
Repair faults or
replace ECM
DTC Code Description
Failure Protection
Operation
Prerequisite of
Releasing Failure
Protection
mashinesoft.com
09120146259
To Next Page
Loading...
Need help?
General
