Changan CS35 User Manual

3.1.13-52
CS35 2013.04
3.1.13-52Electronic Control System - ME7
Easy Stall at Start Diagnosis
Test Conditions Details/Results/Actions
1. Inspect the trouble code
A. Connect the diagnostic tool.
B. Turn the ignition switch to position "ON", diagnose
the engine system.
Is there any DTC?
Y
Go to trouble code diagnosis procedure.
Refer to: DTC Diagnostic Procedure Index
(3.1.13 Electrical Control System - M7,
DTC Diagnosis and Testing).
N
Go to step 2.
2. Air Intake system
A. Turn the ignition switch to "LOCK" position.
B. Inspect the air intake system for block.
Refer to: Symptom Chart (3.1.5 Intake
System, Symptom Diagnosis and Testing).
C. Inspect the air intake system for leakage.
Refer to: Air Intake System Leakage Diag-
nosis (3.1.5 Intake System, Symptom
Diagnosis and Testing).
Is the air intake system normal?
Y
Go to step 3.
N
Repair the air intake system.
3. Crankshaft position sensor
A. Turn the ignition switch to position "LOCK".
B. Disconnect the crankshaft position sensor wiring
harness connector E07.
C. Measure the resistance value of crankshaft position
sensor.
Standard Resistance Value: 20 ℃ (68ºF)731 ~
989 Ω
D. Connect crankshaft position sensor wiring harness
connector E07.
Is the resistance value normal?
Y
Go to step 4.
N
Replace the crankshaft position sensor.
Refer to: Crankshaft Position Sensor
(3.1.13 Electrical Control System - ME7,
Removal and Installation).
4. Inspect the crankshaft position sensor terminal 1 circuit
12
E07
A3113033
mashinesoft.com
09120146259

Changan CS35 Specifications

General

Brand	Changan
Model	CS35
Category	Automobile
Language	English